Description

Trailer Safety Bumper–3″ tall X 8ft / 96″ Long

Molded of hard rubber,  hollow in the middle,  96″ in length. Choose from with 3 different heights. Height measurement is the flat back where it is fastened to the trailer. Comes with pre-cut recessed holes for bolt-on installation. If the length of your bumper is shorter than 96″, you may still order this bumper, but please measure the bolt-hole locations carefully! These bumpers are hollow, and can be cut with a saw. They can also be drilled with additional bolt holes (do it yourself).

Pre-drilled bolt holes:The first hole center is placed 4″ inches from each end, then the remaining hole centers are 11″ inches apart. 9 holes total. The recessed holes are drilled for a 3/8″ bolt (not supplied).

 From the left side: bolt holes are centered at: 4″, 15″, 26″, 37″, 48″, 59″, 70″, 81″, 92″.

OFC: An extra charge in addition to flat-rate shipping charges  for shipping a LARGE, HEAVY OR LONG item by ground.

Trail Pals tip:    For accurate measurements, lay the bumper on a flat surface & measure the flat back for the hole pattern.